Announcement

Collapse
No announcement yet.

Turn a robotic Gearbox into a Manual Gearbox - Need help

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • [Corsa C] Turn a robotic Gearbox into a Manual Gearbox - Need help

    Greetings to all of you.

    I have Corsa 1.2 Tiptronic (2001 - Z12XE) and the Robotic Gear box decided to deteriorate..
    I purchased (in cheap) another Corsa (the same model) but With the manual gearbox.

    Before the mechanical conversion of the gear's, I tried to make sure thet the electronics were normal - Because the Robotic Corsa's ECU does not starting up When the connectors to the gearbox are detached (As if it did not exist).

    so, I switched between the car ECU's and together with the little computer ho sites in the right side on the manifold of course.
    and Instead of replacing the entire switch cylinder of the car key
    I replaced the chip inside the key-but it was no use - They still did not Start up

    It seems that i'm supposed to replace the all switch unit itself.

    What other ELECTRONIC COMPONENTS (computer units, components and connections) should I replace in order for the engine to start up without any identification of the robotic gear as the manual ?

    Thank you in advance for any help and advice regarding this conversion, Aditi
    Last edited by Aditi; 25-10-2017, 09:08 PM.
Working...
X