[Corsa B 1993-2000] 1.2 16v to 1.6 16v wiring help

[ardenblue]

anyone tell me what part of the engne bay loom i need to pul back into the car is it the whole lot or just the part that connected to the ecu on the inlet
or the whole lot that was orginally connected to the 1.2 engine

here the engine loom at the minute untapped and ready to pull it through you can see the two red wires will these need to be cut and brought back through or what


plug from ecu on inlet cut it off or what happens to it


another picture of the two red wires going in a different direction than the rest going into the car

[Coupe77]

You will need the full engine loom and then patch it into the loom
You will also need the the chip and transponder
The part of the loom in your pics will need the new loom patching to it

[ardenblue]

You will need the full engine loom and then patch it into the loom
You will also need the the chip and transponder
The part of the loom in your pics will need the new loom patching to it

im getting the full engine loom ecu and transponder from a tigra but what part of my loom do i need to bring back into the car

[Coupe77]

The bit with the ecu plug then patch the wires into that you might find that some of the wires may be a different colour
Or may need to extended a bit

[ardenblue]

ok so i cut the plug off the ecu plug and bring that inside of the car by the foot well in drivers side

[Coupe77]

I would patch the wires in first though
That way you don't have wires all over the place and cut each wire as you join it