[Non Corsa] siemens ecu pinouts

[g0l1athrulz]

hi guys need some help again, i have an opel monza(not sure what you guys got it as) but i need the ecu pin outs to hopefully try get this car going, i cant remember the exact ecu, will check tomorrow, but i know its an siemens ecu(i will add a pic i found of a bosch ecu(the siemens looks almost the same)

pic of car
Google Image Result for http://upload.wikimedia.org/wikipedia/commons/c/c9/Opel_Kadett_E_rear_20071105.jpg

pic of ecu(mine says siemens easy....)
Vauxhall Cavalier Astra MK2 Opel Ascona C Kadett E 1 8i ECU Engine 90239516 GM | eBay

ok its an siemens ezplus

[Dave]

If you can find out what engine code you have I can see if I have the wiring diagram for it. I only have full diagrams for one specific type of 1.8, so need to check which one you have.

[g0l1athrulz]

ok this engin is a mix up lol, the guy tried converting a 1.6 carb(16sv i think) to a 16se, it has a afm(bosch) and there is a coilpack and a tp100/coil in the boot, so if i can get the pinouts for the ecu, i should be able to get it started(as it is it has an external pickup and a dizy pickup on the motor(one of these will need to go not sure which one)) if i cant get the siemens ecu working, i will probly end up installing an aftermarket ecu(dicktator)

[Dave]

Ok, I can't help with that, but if its of any use, I'll give you what I've got, whihc is an 18SE wiring diagram. I dont know what ECU this would be for, its a bit before my time, over here in the UK you'd be looking at Astra Mk2's though I believe. I think that was the same as the Kadette E

Nothing found for Uploads 18Se Pdf

Dave

[g0l1athrulz]

Ok, I can't help with that, but if its of any use, I'll give you what I've got, whihc is an 18SE wiring diagram. I dont know what ECU this would be for, its a bit before my time, over here in the UK you'd be looking at Astra Mk2's though I believe. I think that was the same as the Kadette E

Nothing found for Uploads 18Se Pdf

Dave

Thanx, will print it out snd see what i can do, looks like it will work

[Rob]

18se and 16se run the same loom. i used an 18se a long time ago in a conversion. most of the important wires are in the big grey plug in the engine bay. take pics of your connectors and ill i.d them.

[g0l1athrulz]

18se and 16se run the same loom. i used an 18se a long time ago in a conversion. most of the important wires are in the big grey plug in the engine bay. take pics of your connectors and ill i.d them.

Connecters i know thanx, the harness i have and the mess of cables thars in the car differs(the big plug that goes into the siemens) so with my harness u dont get spark, so thinking of just re wire the harness to what it should be(i think my harness is for coilpack and the siemens ecu uses tp100/coil setup) if i need more help i will report back here(really thinking of just going aftermarket ecu