Results 1 to 1 of 1

Thread: How To: Drill your Airbox

  1. #1
    Lee
    Lee is offline
    Administrator Lee's Avatar
    Join Date
    Jul 2013
    Location
    East Yorkshire
    Drives
    Evo 9 FQ-320
    Posts
    3,037
    Thanks
    108
    Thanked 270 Times in 216 Posts

    How To: Drill your Airbox

    Welcome to the guide on how to drill you airbox.

    This guide was carried out on a 1.6sport but has also been done on an escort 1.8gti and a 1.4 corsa sport. The basic principles of the guide can be used to drill the airbox on any other car.

    Tools
    Drill
    Drill bits.
    How To: Drill your Airbox-4152.jpg


    Step 1:
    Find your airbox:
    How To: Drill your Airbox-pict0130.jpg


    Step 2:
    Remove your airbox. On this airbox it was secured by two rubber stoppers at the top and a rubber plug type thing at the bottom.
    How To: Drill your Airbox-pict0135.jpg


    Step 3:
    Take the airbox apart. This is just a case of unclipping it and removing the lid and airfilter.
    How To: Drill your Airbox-pict0131.jpg


    Step 4:
    Drill random holes on the left side of the airbox (the side that will be furthest away from the engine, see the picture above and look at the left side of the airbox, the drill holes are clearly visible) using a 1/2 or 3/4 drillbit. You can use other sizes but these sizes are more than sufficient for a meaty roar. Generally speaking the larger the drillbit the deeper the resulting sound.
    (Please note the airbox is upside down in the picture, don't get confused!!! Just try to line yours up with how it is in the picture and drill in similar spots).
    Make sure all drill holes are below the line where the airfilter sits. Under no circumstances drill above this otherwise you will be by-passing your airfilter and suck rubbish into your engine which could ultimately wreck it.
    How To: Drill your Airbox-pict0134.jpg

    How To: Drill your Airbox-pict0133.jpg


    Step 5:
    Clean airbox and reassemble it.
    Put the filter back in, put the lid back on and fasten the two clips, sit back in place, sit the two top rubber mounts into the right holes, pull the lower rubber plug back through the bottom hole on the airbox.

    Result
    You should now be all done. Start it up and take it for a drive to see how it sounds.
    For best results a k&n panel filter is recommended but a standard filter is more than sufficient

    Cost
    Nothing
    Last edited by Lee; 18-07-2013 at 01:46 PM.
    Please contact me via PM if you would like to transfer your AllCorsa Gold Membership over to our VIP Membership. It's completely free to do so.

  2. The Following User Says Thank You to Lee For This Useful Post:

    Shaz91 (23-02-2014)

LinkBacks (?)


Similar Threads

  1. [Corsa B] How-To: De-Restricting Your Airbox
    By Dave in forum Mechanical Tutorials
    Replies: 0
    Last Post: 05-07-2013, 10:54 AM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •