Results 1 to 2 of 2

Thread: Converting 1 Button fog light switch to 2 button

  1. #1
    'VXR' Member Aaron's Avatar
    Join Date
    Jul 2013
    Location
    Boro
    Drives
    1.9 CDTi Vectra SRi
    Posts
    2,900
    Thanks
    1,318
    Thanked 84 Times in 78 Posts

    Converting 1 Button fog light switch to 2 button

    I had a 1 button switch which I purchased with LED's prefitted. I didn't want to shell out so I converted my LED 1 button to LED 2 button by using my new cars 2 button switch.

    It's probably only useful if you end up in my situation, but if yours is a 2 button fog switch and you go and buy a pre-made one you can save yourself a few quid by just swapping the front side/button inside yourself.

    My pictures are likely **** due to phone / batt low - But I was pretty happy with the discovery so thought I would share it.

    by pushing again 6 clips around the switch you can eventually pull the back out;

    I have circled the actual button which is just a piece of rubber pressed by a plastic stick.


    Close up; 2 button ;


    Close up; 1 button;


    Its simply a case of removing that rubber square and putting it on the other switch.


    Swap over your 2 button facia part to the one with LED's and refit;



  2. #2
    'VXR' Member Aaron's Avatar
    Join Date
    Jul 2013
    Location
    Boro
    Drives
    1.9 CDTi Vectra SRi
    Posts
    2,900
    Thanks
    1,318
    Thanked 84 Times in 78 Posts
    This may be in the wrong section, can it please be moved

    Also should clear my desk.
    Last edited by Aaron; 15-09-2013 at 10:12 PM.

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •