Results 1 to 1 of 1

Thread: How To: Reset the ECU

  1. #1
    Lee is offline
    Administrator Lee's Avatar
    Join Date
    Jul 2013
    East Yorkshire
    Evo 9 FQ-320
    Thanked 269 Times in 215 Posts

    How To: Reset the ECU

    This is another extremely common question.
    "How do I re-set the ECU and why do I need to?"

    The reason why is due to any number of factors. Commonly the introduction of a dirty great new air filter or induction kit will upset the ECU's fuelling as the MAS (mass airflow sensor) will be reading a far greater volume than it will inside a stock airbox.
    Also the fitting of a FSE powerboost valve may well give the same erratic symptoms as the fuel is now being pressured into the injector rail at a higher rate than before.
    There is also the occasion when nothing seemingly makes sense and its just running either too rich or too lean.

    So before you go straight for an expensive diagnostic check up or start replacing expensive sensors, re-setting the ECU is the easiest things to do and it costs nothing.

    You'll need to disconnect the battery, ideally overnight (as a residual charge can sometimes mean 30 mins isn't enough). For those with alarms, you might have to just lock it manually with the key and "wing it" for the night or borrow a wheel lock if your nervous.

    In the morning, re-connect the battery and turn the car over. Let it idle for a good 5 mins and be happy that its found base idle satisfactorily (can sometimes take as long as 20 minutes), then take the car out for a 5 mile run using the gears to a decent range / revving freely. This will allow the ECU to recalibrate and hopefully take onboard what the sensors are reading and balance out the fuelling.

    So there you have it. It's costless and it's a doddle. You should always look at this simple method before spending ludicrous amounts on sensors that are actually ok.
    Please contact me via PM if you would like to transfer your AllCorsa Gold Membership over to our VIP Membership. It's completely free to do so.

  2. The Following 4 Users Say Thank You to Lee For This Useful Post:

    Aaron (10-07-2013),icarn (12-08-2016),MasterD (28-03-2015),Muir (04-07-2015)

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts